                
LOGAN QUALITY COMMITMENT:
Logan Graphic Products, Inc. is committed to delivering products that work and exceed our customers' expectations. If you are dissatisfied with your tool's performance, do not understand the directions, or feel that you are not getting the results you expected, DON'T GIVE UP! Contact us by email or phone, and let us help solve your problem. We are here for you, and want you to be thrilled with your Logan purchase. 800 331 6232 or 847 526 5515 |
|
Helpful How-To Tips Adjusting your mat cutter for proper blade depth 
1. Hold the bevel cutter upside down in your hand with the blade activated in the cutting position.
2. Looking at the tip of the blade, measure the exposed amount with a ruler at the same angle as the blade. For standard thickness mat board (4 ply) only 1/8" (0.3175cm) of blade should be seen. To adjust, find the screw head recessed below the bottom of the surface of the cutting head near where the blade is coming out. 3. Turning the screw to the right (clockwise) will decrease the blade depth, the left (counterclockwise) will increase the blade depth. Not all matboard requires 1/8" (0.3175cm). Thicker matboard will require more. Always have the blade depth set so that the backing sheet is scored only slightly. This test and adjustment needs to be done periodically as mat board has many variances of thickness and the depth can increase itself over time with regular use. 4. Another way to test your blade depth is to examine your backing sheet after making a cut. The blade tip should just score into the top of the backing sheet. Cutting even half way through the backing sheet is entirely too much blade. 
|
|