Dealers About Contact link to Logan on Facebook link to Logan on Twitter link to Logan on Instagram link to Logan on YouTube
Logan's Complete Guide to Picture Framing
Installing Hanging Hardware
Guide Navigation
Introduction to Picture Framing & Matting
Designing Your Picture Frames and Mats
Measuring and Sizing Picture Frames and Mats
Costs of Picture Framing
DIY Picture Frames
Mat Cutting
Mat Cutter Choices
Mat Cutting Help, Troubleshooting and FAQs
Mounting Your Artwork
Glazing with Glass and Plastic
Securing or Fitting your Artwork in a Picture Frame
Finishing Your Artwork

Several options exist for hanging your artwork, but the preferred method is picture hanging wire because it provides the greatest ease and flexibility with artwork of any size. Traditionally screweyes have been used for attaching hanging wire to the frame, but in recent years strap hangers with D‑rings have grown in popularity because they lie flat against the back of the dust cover and won't scratch the wall.

To position screweyes or strap hangers, measure  about one-third down from the top of the frame and mark the location. Do this on both sides.

You don't have to be exact in your placement of the hanging hardware. If the two hangers are not exactly aligned with each other, the artwork may not hang straight. But then, of course, you will shift the wire on the nail until it does hang straight. So no harm done.

To attach a screweye to soft or medium wood frames, make a pilot hole in the back of the frame with a scratch awl (Figure CC‑1). Start turning the screweye by hand until it becomes too resistant (Figure CC‑2). Then use the barrel of the screwdriver or a screweye twirler to turn the screweye the rest of the way (Figure CC‑3). To attach a screweye to hardwood frames, pre-drill a hole with a power drill.

Figure CC-1: Make a pilot hole with a scratch awl.
Figure CC-1: Make a pilot hole with a scratch awl.

Figure CC-2: Start turning the screw by hand.
Figure CC-2: Start turning the screw by hand.

Figure CC-3: Use the barrel of a screwdriver to turn the screw the rest of the way.
Figure CC-3: Use the barrel of a screwdriver to turn the screw the rest of the way.

To attach a strap hanger to soft or medium wood frames, make a pilot hole in the back of the frame with a scratch awl. Turn the screw into the wood with a screwdriver (Figure CC-4). To attach a strap hanger into hardwood frames, pre-drill a hole with a power drill and attach the screw with a power screwdriver.

Figure CC-4: Attach a strap hanger with a screwdriver.
Figure CC-4: Attach a strap hanger with a screwdriver.

learning center